Westcreek Colorado Well Depth, Yield, and Cost

How deep are wells around Westcreek?

How much water do wells make near Westcreek?

How deep are Westcreek wells?

Westcreek wells have a median reported depth of 250 feet. The middle half runs from 130 to 380 feet, so a driller estimating a new well here should not rely on the median alone. Most recorded wells fall between 100 and 300 feet, while another substantial group reaches 300 to 600 feet.

The local range is wide. 14% are under 100 feet, 44% are 100 to 300 feet, 36% are 300 to 600 feet, and 6% exceed 600 feet. The deepest recorded well is 1,250 feet. Granite and gneiss can change quickly from one lot to the next, so nearby completed wells are useful for bidding but are not a guarantee.

What water yield can a Westcreek well make?

The reported median well yield near Westcreek is 6.0 gallons per minute, with the middle half between 2.3 and 9.8 gpm. That is a workable range for many household systems, but the pumping rate is only one part of the evaluation. Storage capacity, recovery, pressure equipment, and the intended household use also matter.

Low-producing wells are present in the records: 7% report under 1 gpm, while 34% report 1 to 5 gpm. Most, at 57%, report 5 to 15 gpm, and 2% exceed 15 gpm. Ask for the well construction report and yield test before treating a neighboring result as an expectation for your lot.

Westcreek water levels and the local trend

Among the 26 wells reporting a static water level, the median depth to water is 99 feet. The middle half is 61 to 159 feet below the surface. This is the water level when the well is not being pumped, not the same thing as the depth of the well or the water available during sustained pumping.

The decade figures suggest a possible change that deserves investigation: the median reported static level was 68 feet below the surface in the 2010s and 125 feet in the 2020s. The sample is limited, and measurement conditions may differ, so this does not prove a basin-wide decline. For a purchase, compare recent well tests, pump settings, and neighboring records rather than relying on the median alone.

Westcreek permit history and local drillers

Westcreek has a long permit history, with the largest recorded decade totals in the 1990s and 1980s. The records show 108 permits in the 1990s, 87 in the 1980s, and 80 in the 1970s. Permits continued into the present, with 27 in the 2020s and the newest permit year listed as 2025.

The most active names in these records are Woods Drilling Inc. (Woods, William D.) with 68 permits, Mountain Well Improvement LLC (Wiley, David D.) with 66, and Woods Drilling Inc. (Woods, William L.) with 63. These are permit-record counts, not endorsements. Confirm current licensing, insurance, scope, and references before hiring.

What does a new well cost near Westcreek?

Westcreek drilling is priced around fractured mountain bedrock, including granite and gneiss. The supplied cost model uses $65 to $100 per foot. At the local median depth of 250 feet, the drilled hole is estimated at about $16,200 to $25,000.

A finished system is estimated at $22,200 to $37,000 when the pump, pressure tank, trenching, and electrical work are included. Treat that as a planning range, not a fixed quote. Depth, difficult rock, access for the rig, casing and grout requirements, power distance, and site layout can move the total. Get the drilling and completion scope in writing, including what happens if the hole is low-yield or dry.

Risks to check before buying or building

Most permits identify an unnamed or fractured-bedrock aquifer: 474 wells use that description. Only 4 identify an alluvial aquifer, and none are listed in a Denver Basin aquifer. Fractured bedrock can produce good water on one parcel and poor water on another, making low yield, a dry hole, and variable recovery important risks to price and investigate.

There are 26 historic mine features and 1 PFAS sampling or contamination site mapped within about 10 miles. No EPA Superfund or cleanup sites are mapped in that area. That does not replace water testing. Test an existing well for relevant contaminants, inspect casing and grout, locate the septic system and replacement area, and confirm the lot can meet well, septic, driveway, and building requirements.

A practical plan for a Westcreek lot

Start with the Colorado DWR permit, construction report, pump test, and service history for any existing well. Verify the actual static level, tested yield, pump depth, storage, and water quality. If the lot is vacant, review nearby records from Westcreek and surrounding mountain communities such as Woodland Park, Perry Park, Palmer Lake, Divide, Florissant, and Larkspur, while giving the greatest weight to wells closest to the parcel.

Before closing, have a driller discuss likely depth, access, casing and grout, and the cost of a low-yield outcome. Confirm the intended permit and household use with DWR. Exempt household-use wells have a 35 gpm pumping limit, and over-appropriated basins may require an augmentation plan. Coordinate the well location with septic, the home, electrical service, and winter access before construction begins.

Well permits by decade near Westcreek

What a new well costs in Westcreek, CO

How this is built: the median permitted depth here times the per-foot range for this ground, plus the normal system costs. A lot at the 75th-percentile depth (380 ft) would run roughly $30,700–$50,000. See the full Colorado well cost guide.

Environmental sites mapped within about 10 miles

Counts come from EPA, USGS and state datasets layered on the Colorado Well Finder map. A count is not a verdict on any one well; it tells you what to test for.

Buying land near Westcreek? Know what it costs to build before you buy the dirt.

A listing photo can't tell you whether a lot is a dream or a money pit. Two parcels near Westcreek can carry the same asking price while one needs an $80,000 driveway and a $45,000 engineered septic the other doesn't. The well numbers on this page are the start of that answer. A Tri-Lakes Site Feasibility Report is the rest of it: a licensed general contractor, excavator and septic installer reads the parcel the way we would if we were about to build on it, and puts the real cost in writing before your money is committed.

Spend a little to know. Or gamble a lot to guess. Realtors sell the view and inspectors look at houses that already exist. We're the people who'd build it, so we catch what quietly turns a "great deal" into a budget disaster: bad access, buried rock, steep grade, soil that won't pass for a normal septic, water that's a fortune to reach. And if the lot is good, you've already got a builder ready to do the work, driveway to drywall.

• Instant Online Report, $99 — type the address and get a buildability read on the spot: parcel, terrain and slope, soil and septic outlook. Cheap enough to run on every lot you're shopping.
• Desktop Report, $500 — a contractor's from-the-desk feasibility read: Regulation 43 and county code, GIS parcel data, terrain, flood and drainage, soil and septic viability, setbacks and buildable envelope, nearby well depths from our 591,000-well database, the likely driveway route, and a preliminary site-development cost breakdown.
• On-Site Report, $2,000 — everything above, then boots and a drone on the actual ground: house pad and septic zone located, access and winter conditions checked, rock and soil observed in person, a 15 to 20 page written opinion you can hand a lender or seller. Credited toward your project if you build with us.

Under contract, comparing parcels, or a realtor with a rural listing whose buyers keep asking "what will it cost to build here?" This is the due-diligence step almost everyone skips, and the one that saves the most.

Common questions about wells in Westcreek

Keep researching

More in Douglas County

All wells in Douglas County — county-wide depth, yield and cost figures.

Nearby areas