Colorado Well Finder › Wells by county › El Paso County › Fountain
For rural property near Fountain, the local well records point to relatively shallow wells with generally useful reported yields. Among 1,418 permitted wells within 5 miles, 881 report a total depth and 164 report a pump yield, so the depth picture is stronger than the production picture.
The records also show an important limitation: most permits identify an unnamed or fractured-bedrock aquifer, and only 27 wells report a static water level. Use these figures to screen a property and plan a bid, not as a guarantee that a particular lot will produce the same water.
Figures are computed from Colorado Division of Water Resources permit records for permitted wells within 5 miles of Fountain. Not every permit reports every field; each statistic uses the wells that report it.
| Depth statistic | Feet |
|---|---|
| 25th percentile | 37 |
| Median | 50 |
| 75th percentile | 62 |
| 90th percentile | 77 |
| Deepest on record | 600 |
| Aquifer named on permits | Wells |
|---|---|
| unnamed / fractured-bedrock aquifer | 1,315 |
| Alluvial | 28 |
| Quaternary Alluvium | 8 |
| Yield statistic | gpm |
|---|---|
| 25th percentile | 10.0 |
| Median | 13.8 |
| 75th percentile | 25.0 |
| Median depth to water | 27 ft |
| Median water level by decade | Depth to water |
|---|---|
| Not enough dated measurements | — |
The median recorded well depth near Fountain is 50 feet. The middle half runs from 37 to 62 feet, and 97% of wells are under 100 feet. That is a useful starting point for a drilling estimate: a conventional bid based on a 50-foot hole may fit many sites, but a driller still needs room for casing, grout, development, access, and the chance of going deeper.
The range is not uniform. The deepest well in the records reaches 600 feet, while 2% fall between 100 and 300 feet. Ground conditions are listed mainly as unnamed or fractured-bedrock aquifer, with 1,315 wells in that category. Mixed sedimentary and alluvial ground can change the result from one parcel to the next, even close to Fort Carson or Security-Widefield.
Among the 164 wells that report a pump yield, the median is 13.8 gallons per minute. The middle half is 10.0 to 25.0 gallons per minute. Forty-six percent report 5 to 15 gpm, and 45% report more than 15 gpm. Only 1% report under 1 gpm, while 9% fall between 1 and 5 gpm.
That distribution is encouraging for ordinary household planning, but it is not a promise for an untested lot. Yield records are available for far fewer wells than construction records. Ask for the pumping information and permit restrictions on the specific parcel. A household well is not automatically an irrigation well, and an exempt household-use well remains subject to Colorado rules, including the 35 gpm exempt-well pumping limit.
Only 27 permitted wells near Fountain report a static water level. In that small group, the median depth to water is 27 feet, with the middle half from 18 to 35 feet. That gives a rough planning reference for pump setting and trench work, but it should not be treated as a measured water table for every property.
The permit counts by decade show activity through the area’s history, including 235 permits in the 1990s, 266 in the 2000s, 170 in the 2010s, and 39 in the 2020s. Those counts describe permitting, not a falling or rising water table. A current driller’s test and nearby well checks are more useful than assuming the water level has moved in one direction.
Fountain’s records span permits from the 1950s through the newest permit year, 2025. The largest listed group of drillers is Authorized (Pe, Pg), associated with 274 records. M & B Drilling Co. (Mateyka, John E.) appears on 75 records, and Hamacher Well Works Inc. (Hamacher, Alan Ray) appears on 69.
These names show who appears most often in the records; they are not a recommendation or proof that a company is available for a new job. Before hiring, verify the driller’s current Colorado authorization, ask what is included in the bid, and confirm who handles the permit, water-quality testing, pump installation, pressure tank, and final connections.
The cost model for Fountain assumes mixed sedimentary and alluvial ground and a drilling rate of $50 to $75 per foot. At the local median depth of 50 feet, the drilled hole is estimated at about $2,500 to $3,800. That is only the hole, not the complete water system.
A finished well with pump, tank, trenching, and electrical is estimated at $8,500 to $15,800 at that median depth. A shallow site can still cost more than the drilling footage suggests if access is difficult, the pump system needs special work, or the well must be deepened. Get a written bid that separates drilling, casing and grout, development, testing, pump equipment, trenching, and electrical.
Within about 10 miles of Fountain, the mapped records include 77 PFAS sampling or contamination sites, 17 historic mine features, and 3 EPA Superfund or cleanup sites. These locations do not establish that a particular property’s well is contaminated, but they are a reason to review environmental maps and test existing or newly drilled water before relying on it.
Low yield and dry-hole risk still need a parcel-level review, especially because only 164 wells report pump yield and the aquifer descriptions are mostly unnamed or fractured bedrock. Confirm septic setbacks, reserve area, driveway access, utility routing, and the proposed building location before drilling. A well site that works for water may not work for the septic system or house plan.
Start with the permit file for the exact parcel, then compare nearby wells in Fountain, Fort Carson, Security-Widefield, and Stratmoor. Look for recorded depth, yield, static water level, use, aquifer description, and construction details. Neighboring wells can reveal local variation that a countywide median cannot.
For a new build, have the driller and septic designer review the lot together before finalizing the house, driveway, and utility layout. Confirm the intended use under the permit; domestic, stock, irrigation, and monitoring wells appear in the local records, but those categories do not carry the same rights. If the property is in an over-appropriated basin or the proposed use is broader than household use, ask about augmentation-plan requirements before closing.
| Decade permitted | Wells |
|---|---|
| 1950s | 33 |
| 1960s | 44 |
| 1970s | 121 |
| 1980s | 93 |
| 1990s | 235 |
| 2000s | 266 |
| 2010s | 170 |
| 2020s | 39 |
| Most active drillers on record | Wells |
|---|---|
| Authorized (Pe, Pg) | 274 |
| M & B Drilling Co. (Mateyka, John E.) | 75 |
| Hamacher Well Works Inc (Hamacher, Alan Ray) | 69 |
How this is built: the median permitted depth here times the per-foot range for this ground, plus the normal system costs. A lot at the 75th-percentile depth (62 ft) would run roughly $9,100–$16,650. See the full Colorado well cost guide.
Counts come from EPA, USGS and state datasets layered on the Colorado Well Finder map. A count is not a verdict on any one well; it tells you what to test for.
The numbers above are the area average. Your lot is one point on the map. Search the address to see the real depth, yield and aquifer of each permitted well around it.
Map wells near FountainTri-Lakes Contracting is a licensed Colorado contractor serving Fountain and nearby El Paso County communities with access driveways, site development, new-build septic systems, and custom homes. Bring the well, septic, driveway, and house layout together before construction starts.
Licensed Colorado custom home builder · licensed driveway & excavation contractor · licensed septic installer
A listing photo can't tell you whether a lot is a dream or a money pit. Two parcels near Fountain can carry the same asking price while one needs an $80,000 driveway and a $45,000 engineered septic the other doesn't. The well numbers on this page are the start of that answer. A Tri-Lakes Site Feasibility Report is the rest of it: a licensed general contractor, excavator and septic installer reads the parcel the way we would if we were about to build on it, and puts the real cost in writing before your money is committed.
Spend a little to know. Or gamble a lot to guess. Realtors sell the view and inspectors look at houses that already exist. We're the people who'd build it, so we catch what quietly turns a "great deal" into a budget disaster: bad access, buried rock, steep grade, soil that won't pass for a normal septic, water that's a fortune to reach. And if the lot is good, you've already got a builder ready to do the work, driveway to drywall.
Under contract, comparing parcels, or a realtor with a rural listing whose buyers keep asking "what will it cost to build here?" This is the due-diligence step almost everyone skips, and the one that saves the most.
Driveway, site work, septic or a build near Fountain. Licensed GC, excavator and septic installer.
Got it. Tri-Lakes will get back to you shortly.
Something went wrong sending that. Email kyle@trilakes.co instead.
The median recorded depth near Fountain is 50 feet, with the middle half between 37 and 62 feet. About 97% of recorded wells are under 100 feet. The deepest record is 600 feet, so a buyer should treat the median as a planning reference rather than a guarantee for a specific lot.
The local cost model uses $50 to $75 per foot. At the 50-foot median depth, the drilled hole is estimated at $2,500 to $3,800. A finished system with pump, tank, trenching, and electrical is estimated at $8,500 to $15,800. Site access and unexpected depth can change the final bid.
Among the 164 local wells reporting pump yield, the median is 13.8 gallons per minute. The middle half produces 10.0 to 25.0 gpm. Forty-six percent report 5 to 15 gpm and 45% report more than 15 gpm. These figures do not guarantee the yield of an untested parcel.
The local records include 77 mapped PFAS sampling or contamination sites within about 10 miles, along with 17 historic mine features and 3 EPA cleanup sites. Those maps do not prove contamination at a specific well. Test the property’s water, review nearby environmental records, and retest after a new well is completed.
Review the exact permit, construction depth, pump yield, static water level, permitted use, and nearby wells. Only 27 local wells report static water level, so site-specific information matters. Also confirm septic setbacks, access, utilities, and building placement. Broader uses may require different water rights or an augmentation plan.
All wells in El Paso County — county-wide depth, yield and cost figures.
Driveway, septic, site development, feasibility or a custom build near Fountain.
Shopping a lot? Run the $99 instant buildability check →